Text Us
    Back to Home

    Navien Tankless Water Heaters in Greer, SC

    We install and service Navien NPE condensing tankless water heaters: tank-to-tankless swaps, propane units, built-in recirculation, flushing, and the error codes that show up on the front panel. Here's what Navien's own manuals say about the questions people ask most.

    Navien Tankless Water Heaters

    About This Service

    Our Navien work runs from tank swaps to propane. In Greer we removed an old 40-gallon gas tank and installed a Navien high-efficiency tankless with code-compliant gas line sizing, condensing venting and a condensate drain. In Spartanburg a homeowner upgraded from a tank system to a Navien, with gas line sizing and pressure verification, intake and exhaust venting, isolation valves and a condensate drain. A Greenville install got gas line sizing and a regulator, an expansion tank and isolation valves, and a condensate neutralizer. One homeowner whose old tankless had shorted out upgraded to a Navien propane unit. In Simpsonville we troubleshot a Navien's recirculation for a homeowner with long waits for hot water, checking the recirculation settings, the pump and check valves and the line configuration. And we flush Navien tankless heaters to remove mineral buildup.

    Navien's user manual gives each error code a short action list. E003 is ignition failure, and Navien's listed fix is to make sure the main gas supply valve is open. E110 is abnormal air pressure: Navien says to make sure the exhaust pipe is clear and to clean the intake air filter, which it says should be cleaned every 3 to 4 months; a clogged filter stops the heater and brings up code 110. E016 (heat exchanger overheating) and E030 (exhaust overheating) point to cleaning the cold water inlet filter and flushing the heat exchanger. E515 is a circuit board fault: make sure the electrical cord is properly grounded. E407 is the hot water outlet sensor, and like most other codes it says to contact Navien Technical Support. E760 isn't a fault; it's a flushing and service alarm telling you to have the installer perform routine service. You can try a reset by pressing the Back button; if a reset doesn't solve it, Navien says to check the troubleshooting section or call Technical Support, and its blog advises not to just keep resetting a recurring code.

    How often a Navien needs flushing depends on your water. The hardness table in Navien's installation manual lists no treatment and no flushing for soft water, up to 60 mg/L, and flushing once a year from 61 mg/L up when no water treatment device is installed. A softener or Navien's PeakFlow is recommended from 61 mg/L, highly recommended from 161 and required above 200. City water around here is soft: Greenville Water averages under 6 mg/L of hardness, SJWD about 17 and Greer CPW about 35. Wells vary, so test before deciding. Navien calls flushing the heat exchanger a somewhat complicated procedure, says to contact an authorized technician or licensed professional if you're unsure of any step, and notes that improper maintenance can void the warranty. It also says to inspect the vent termination and air intake annually.

    Condensate is the other upkeep item on a condensing heater. Navien says the condensate is acidic, with a pH of 3 to 5. If it drains through a neutralizer, Navien says to check the neutralizer every few months for depletion during the first year and to replace the media when the pH drops below the local water authority's minimum, or below 6.0 if none is set. The drain line can't be capped or plugged, and installing the heater where there's no drain voids the warranty.

    No hot water with no code is often flow. Navien's minimum flow is 0.5 gallons a minute (lower on A2 models with ComfortFlow recirculation active), and its troubleshooting table points to a clean cold water inlet filter, shutoff valves that are open, a faucet opened wide enough, and, if an external recirculation system is installed, a check valve on the return line. Navien says measuring inlet gas pressure is for a licensed professional only.

    Sizing comes down to flow. Navien's spec sheet rates the NPE-240 at 199,900 BTU/h and 11.2 gallons a minute at a 35°F temperature rise, the NPE-210 at 180,000 BTU/h and 10.1, and the NPE-180 at 150,000 BTU/h and 8.4. At a 45°F rise those drop to 8.7, 7.8 and 6.5. Navien's A2 models come with a built-in buffer tank and recirculation pump.

    In winter, a Navien protects itself only while it has power. Navien's user manual says its freeze protection requires electricity and works whether the unit is switched on or off, as long as the power supply stays connected, and says not to close the gas valve except for routine maintenance, because that limits additional freeze protection on A2 models. It doesn't protect the pipes leading to the heater or the condensate line: Navien says that if the condensate line freezes, the unit shuts down to protect itself, leaving the water inside vulnerable to freezing. In a power failure the freeze protection won't operate, and in cold weather areas where outages are common, Navien says to drain the heater completely if the power will be off for an extended period. Damage due to freezing isn't covered by Navien's limited warranty. Navien says outdoor installation should only be considered in mild climates, and requires its Outdoor Vent Kit when it is.

    A tank-to-Navien swap is mostly gas and venting. Navien recommends connecting the heater as the first water heater downstream of the gas meter, and says not to use 1/2-inch corrugated connectors or tubing. Venting is solid-core PVC or CPVC, polypropylene or stainless steel (never cellular-core PVC for the exhaust), up to 75 feet on 2-inch pipe or 150 feet on 3-inch, less for each elbow. NPE-2 heaters ship set for natural gas; Navien says this heater cannot be converted to propane without its Propane Gas & High Altitude Conversion Kit.

    Signs You May Need Navien Tankless Water Heaters

    • E003, E110, E016 or another code on the front panel
    • E760 flushing and service alarm
    • Long waits for hot water on a recirculating A2
    • Water that runs hot, then cold
    • A dripping or blocked condensate line
    • An old tank you want to replace with a Navien

    What's Included

    • Navien tankless installation and replacement
    • Tank-to-tankless gas conversion
    • Propane Navien installation
    • Recirculation setup and troubleshooting
    • Flushing and descaling
    • Inlet water filter cleaning
    • Condensate drain and neutralizer service
    • Error code diagnosis

    Why Choose Us

    • Navien installs in Greer, Greenville and Spartanburg
    • Code-compliant gas line sizing and venting
    • Licensed in South Carolina and North Carolina
    • Veteran-owned local plumber in Greer

    Navien Tankless Water Heaters FAQ

    Ignition failure. Navien's user manual lists one action: make sure the main gas supply valve is open. If it is and the code keeps coming back, Navien says to contact Technical Support or have a licensed professional look at it.

    Press the Back button on the front panel. Navien says resetting may resolve minor problems; if it doesn't, check the troubleshooting section or contact Technical Support. Navien's blog also advises against just resetting a recurring code over and over.

    Navien's installation manual ties it to hardness: no flushing listed for soft water up to 60 mg/L, and once a year from 61 mg/L up when no water treatment device is installed. City water here is soft; wells vary. Navien also says to clean the air intake filter every 3 to 4 months.

    It depends on how much hot water runs at once and how cold the incoming water is. Navien rates the NPE-240 at 11.2 gallons a minute and the NPE-210 at 10.1 at a 35°F rise, and 8.7 and 7.8 at a 45°F rise.

    Yes, with Navien's Propane Gas & High Altitude Conversion Kit, which Navien says a qualified service agency must install. NPE-2 heaters ship set for natural gas. We've installed a Navien propane unit for a homeowner whose old tankless had shorted out.

    Navien says tankless heaters typically last 15 to 20 years or more with proper installation, good water quality and routine maintenance. Its residential warranty on the NPE-A2 covers the heat exchanger for 15 years, parts for 5 and labor for 1, with shorter terms if an external pump circulates continuously. It excludes installs by a non-licensed installer, and Navien says buying online through e-commerce channels voids it.

    It can. Navien says its freeze protection needs electricity and won't operate in a power failure; in cold weather areas where outages are common, it says to drain the heater completely if the power will be off for an extended period, and damage from freezing due to power loss isn't covered by the warranty. During extreme cold, Navien's blog says a pencil-width stream of hot water from a faucet can prevent internal freezing.

    On A2 models, the built-in recirculation can preheat the line. Navien's modes are Always On, Intelligent and Weekly, and HotButton in external mode with added accessories. Recirculation uses more energy, and in external recirculation mode the built-in pump is limited to 100 feet of 1/2-inch or 500 feet of 3/4-inch copper of equivalent length.

    Navien Tankless Water Heaters Near You

    We provide navien tankless water heaters to homeowners and businesses across the Upstate SC area. Select your city to see local service info.

    Ready to get started?

    Call us now or request a free quote — we respond within minutes.

    864-279-4461