Tub-to-Shower Conversion in Greer, SC
Taking out a tub for a walk-in shower changes more plumbing than it looks like: the drain, the trap, the waterproof floor and the valve. Frontline Plumbing does the plumbing side of tub-to-shower conversions in Greer and across the Upstate, and leaves the floor ready for the liner test.

About This Service
One of our conversions started as a 45-year-old fiberglass tub/shower. The customer's review says Matt upgraded the plumbing for a new walk-in shower, replaced the damaged subfloor and installed the shower pan.
The drain changes first. South Carolina's residential code (2021 edition) requires a shower drain outlet of at least 1 1/2 inches, and sizes the shower trap by the total flow through the showerheads and body sprays: at least 1 1/2 inches for 5.7 gallons a minute and less, at least 2 inches above that up to 12.3. A bathtub's trap is at least 1 1/2 inches, with or without a shower head. The code caps a shower head at 2.5 gallons a minute at 80 psi, so adding body sprays is what can push the trap to 2 inches.
A tiled shower floor built on site needs a liner under it. The code lists the liner materials (sheet lead, sheet copper, plastic sheet liners meeting ASTM standards, hot mopping or a bonded waterproof membrane), requires an approved flanged drain with a clamping ring or other device and weep holes, and where there's a curb, sets it 2 to 9 inches deep from the top of the curb to the top of the drain; the floor slopes toward the drain between 1/4 and 1/2 inch per foot. South Carolina adds a test: the liner is filled to the lesser of the threshold depth or 2 inches and must show no leakage for at least 15 minutes, at the final plumbing inspection. Under the 2024 codes the state has adopted to take effect January 1, 2027, that test can be done at the rough or the final plumbing inspection, at the builder's discretion.
The valve changes too. The code requires shower and tub/shower valves to be pressure-balance, thermostatic or a combination, with a limit set so the water doesn't exceed 120°F. On Delta's MultiChoice 13/14 series valves, Delta says an unused outlet port is sealed with a pipe plug, and Moen's INS162L tub/shower trim sheet has a shower-only setup with a 1/2-inch plug. Height is the other question: Moen's INS2151D sheet puts a tub/shower valve 32 inches above the tub floor and a shower-only valve 45 to 48 inches above the shower floor.
The code's minimum shower is 900 square inches of interior area and 30 inches in its smallest dimension (or 25 inches if the shower has at least 1,300 square inches), with a 22-inch clear opening, and hinged shower doors must open outward. In Greenville County, the county says plumbing permits are required for new plumbing fixtures or for relocating plumbing fixtures.
Replacing a fiberglass shower with tile, without taking out a tub, is covered on our shower installation page.
Signs You May Need Tub-to-Shower Conversion
- Stepping over the tub wall has gotten hard
- A tub nobody in the house uses for baths anymore
- Body sprays planned for the new shower (the trap may need to grow)
- An old tub/shower valve that isn't pressure-balance or thermostatic
What's Included
- Tub drain removed and a shower drain set where the floor slopes
- Trap sized to the shower's total flow
- Liner and flanged drain ready for South Carolina's liner test
- Valve set for shower-only use, with the 120°F limit
- Old tub spout outlet plugged
Why Choose Us
- Trap, liner and valve brought to code together
- Licensed in South Carolina and North Carolina
Tub-to-Shower Conversion FAQ
Tub-to-Shower Conversion Near You
We provide tub-to-shower conversion to homeowners and businesses across the Upstate SC area. Select your city to see local service info.
Sources
- South Carolina Residential Code 2021, Chapter 27: showers (P2708), shower receptors and liners (P2709) (UpCodes)
- South Carolina Residential Code 2021, Chapter 32: trap sizes (Table P3201.7) (UpCodes)
- South Carolina Residential Code 2021, Chapter 29: shower head flow (Table P2903.2) (UpCodes)
- SC Building Codes Council: 2021 code modifications (shower liner test, P2503.6)
- SC Building Codes Council: 2024 modification index (shower liner test at rough or final)
- SC Building Codes Council minutes, Aug 26, 2025 (2024 codes effective January 1, 2027)
- Moen: INS2151D one-handle tub/shower and shower-only valve trim
- Moen: INS162L one-handle tub/shower trim
- Delta: MultiChoice 13/14 series valve installation 72264 (retailer copy)
- Greenville County AnswerBook: permits